1. After cleaning the linear guides, apply liquid‑type bearing lubricating oil to the linear guides, then run the axes back and forth for lubrication. There is no need to remove the bearings.
2. You may purchase replacement spare parts from us when the bearings are damaged.
3. Blow off cutting dust from the machine with compressed air after every use. Depending on operating frequency, apply lubricating oil (ordinary clear, low‑viscosity liquid lubricant) to the linear guides and screw rod every two weeks or every month.
............

1. Water cooled spindle
If your machine uses a water-cooled spindle, you should ensure to clean the water and the pump. The water cooled spindle must absolutely be used with water. The cooling water temperature should be < 35 degrees, it’s advised to check the water temperature during processing to prevent high temperature to lead to spindle overheating.

2. Keep clean
After each use of the machine, be sure to clean the dust on the platform and drive unit. Use compressed air to blow dust out of the control box (Do not use brushes or any other tools which could produce electrostatic electricity), check the screws of the wire plugs to ensure an optimal contact.

3. Lubrication weekly
Lubricate the rails and ball screws weekly with special grease for rails. If you do not have access to it in you local market, you can use high-speed bearing grease (lithium grease, white, suitable temperature: -20 °C ~ 120 °C).

4. Idling
If you plan on not using the machine for a long time............

About Grounding:

Prepare a thick copper wire , one end attached to the foot of the machine working table or any screw of the working table, and the other end connected to the Metal water pipes at home, or nailed a large nail into the ground then connect it to the copper Wire.............

About cooling water:

1. The volume of the cooling water tank should be greater than 20L.
2. You can use a plastic container(barrels) with a lid. Prevent dust falling into the water.
3. The cooling water temperature should be controlled below 35 degrees Celsius. Use a large capacity water tank can effectively reduce the water temperature.
4. You can use purified water or tap water as cooling water.
5. You can add 1% ~ 3% liquid rust to the cooling water (liquid rust for automobile water tank can be used).
6. The water pump must be completely submerged in the water.
............

For a water-cooled spindle, we need to use correct ways to maintain it.
1. The cooling water, you can choose either tap water or deionized water. Please add a little common antirust into water ( the kind used in water tank of cars is OK).

2. You need to ensure that the spindle runs normally, so that you must avoid the water-cooled spindle lacks water. During operation, please check the surface temperature of the spindle regularly to prevent from a hot spindle.

3. Please measure the temperature of the cooling water periodically, you’d better keep the cooling water within 30 degree centigrade. When the environment temperature is high ( in summer), please use a big-size water tank. When the temperature of the cooling water is rising, you can lower the temperature by adding more water.

4. If you use tap water, please change the water periodically ( change one time in a week)

5. When the temperature in winter is below 5 degree centigrade, please add some anti-freezing solution into the cooling water.

6. If you don’t use the machine for a long time, you must use compressed air to blow out the water in the spindle until there is no water in it............